Bending acrylic rod
4 posts
• Page 1 of 1
Bending acrylic rod
by hrtpaul » Mon Jul 28, 2014 3:18 pm
Hey peeps. Anyone know how to bend 10mm clear acrylic rod without breaking it? I wanna mount an RF-4E through the exhaust at a bit of an angle in a climbing turn. Ta guys
Head A/CAM Phantom Phanatic, Shit Stirrer and Karma Bus Driver toot fkn toot 
- hrtpaul
- Posts: 4165
- Joined: Sat Apr 12, 2014 10:44 am
- Location: Like I'm gonna tell you lot
Re: Bending acrylic rod
by Tony P » Mon Jul 28, 2014 5:33 pm
In the oven mate. I'll try and find an article for temps etc. I used a piece of curved wood to bend it around. Oh wear gloves!
You don’t concentrate on risks. You concentrate on results. No risk is too great to prevent the necessary job from getting done- Chuck Yeager.
-
Tony P - Posts: 549
- Joined: Tue Apr 15, 2014 12:54 pm
Re: Bending acrylic rod
by RayS » Tue Jul 29, 2014 8:58 am
...or use the other half's hair drier. Don't hold the heat on one part too long or it starts to blister. I now have a paint stripping heater gun I use to do mine.
Then have a former ready and wrap it around it. Leave it to cool.
Then have a former ready and wrap it around it. Leave it to cool.
Ray
-
RayS - Posts: 2200
- Joined: Thu Apr 17, 2014 10:24 am
- Location: RAdelaide!... YPAD
Re: Bending acrylic rod
by hrtpaul » Tue Jul 29, 2014 3:26 pm
Thanks guys. I've got a 2m length so I have a few goes at it before I run out
Head A/CAM Phantom Phanatic, Shit Stirrer and Karma Bus Driver toot fkn toot
- hrtpaul
- Posts: 4165
- Joined: Sat Apr 12, 2014 10:44 am
- Location: Like I'm gonna tell you lot
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 20 guests