G'day chaps,
after my third application of Milliput and three days of sanding the saddleback problem is rectified and all the seams are now "sweet". There are a few minor flaws that will be rectified after I throw some primer on to make sure I dont miss anything. I have left the tailplane off for now, leaving that difficult fairing job for later as don't want to break it off while I am crow-barring and hammering the wing on.
As can be seen from the pictures, the wingroots on the fuselage are larger than the centre section hole in the Heller wing. I will not cut up the wing because I don't want to ruin in it in case this project goes sour.
I will be bracing the fuselage above and across the wing join, putting some kind of floor / spar structure to fasten the wing to then fill the gaps with balsa / plastic / milliput. You can see the nose is heavy...there is a ton of lead in it, I wanted to make sure it was not a tail sitter and I knew I had to add weight to the tail as unwanted side effect of bracing the tail.
I am starting to get a bit excited about this.