Paul's favourite.....a 1/72 Piper Aztec!

[Uros]

Looking good!

[Cap'n Wannabe]

Just to give you an idea of what I'm up against...



And here you can see the sink marks a bit better....I've started sanding the RH side windows. The LH side is done for now - I sanded the marks off the inside, then separated the windows into individual pieces. This will allow me to position them proud of the fuselage, then sand them flush.

[F-27pax]

I've got one of these kits and I'm admiring your work and know what you're up against. It will take me a while to get over making the Aurora Jet Commander so I probably won't work up the courage to have a go at this one for a while.
Leigh

[Cap'n Wannabe]

There's a few minor issues that I've found so far, the worst probably being the windows. The nacelles didn't *quite* want to line up - nothing a touch of sanding won't fix - the wing roots are going to need some work, and there's a gap in the nose wheel well. Other than that (so far) it's not too bad a kit.

[Cap'n Wannabe]

Almost done with the LH windows....they're still a touch proud of the fuselage, and need more cleanup, but they're looking good.....at least to my eye

[RayS]

COming along slowly, nice to see the care you are taking with the window fit Damo.

I think I have a couple of these hiding in the stash. Should try and find them

[Cap'n Wannabe]

LH windows done, RH on the way. I had a little difficulty positioning the RH windows because I sanded a little too much around the edges, so they fell through the openings. Yes, I dropped all 3 windows at one time or another....but the carpet monster must've been on holiday..

[Ansett A330]

....but the carpet monster must've been on holiday..

Yes it would have been on holiday if it was a Queensland Carpet Monster as it was a long Weekend this Weekend.

Nice work. Of all the Kits I've got I don't think I've got one of these but paying close attention in case I have and live long enough to make it.